Luma Touch Support Forums

Ken Burns effect
Page 1 of 1

Author:  markh [ Tue Jan 10, 2017 9:42 am ]
Post subject:  Ken Burns effect

Does anyone know how to do the Ken Burns effect for photos in Luma Fusion?

Author:  Mark NZL [ Tue Jan 10, 2017 10:09 am ]
Post subject:  Re: Ken Burns effect

Double tap the clip to go to the clip editor.
In the frame and fit tab add a keyframe to the beginning and end of the clip.
Enlarge and position the image in one of those with two finger dragging.

This works for videos too and you can mix it up with other keyframe effects. Have fun

Author:  markh [ Tue Jan 10, 2017 2:51 pm ]
Post subject:  Re: Ken Burns effect

Ah ok, thanks!

Author:  brianflock [ Sun May 21, 2017 1:31 pm ]
Post subject:  Re: Ken Burns effect

I see that v 1.3 has some Ken Burns-type effects like panning up-down-left-right.

I'm not an expert and don't understand the keyframe terminology of this thread.

For example, I want to start at the top left of a static pic and pan down smoothly to the bottom right of the pic.

Any tips on how to do that?

Thank you.

Author:  tmorgan [ Wed May 24, 2017 9:36 pm ]
Post subject:  Re: Ken Burns effect

Hi Brian,

Here is a short silent video that shows first adding a preset effect and then double tapping on the clip to go adjust the position of the start and tail. You can pinch in or out to resize and drag to position the clip to anywhere you like it at the head and tail (and anywhere in-between. The clip will animate between any two keyframes (blue dots)

It is late tonight, but I can make a more extensive video for you if needed.

Page 1 of 1 All times are UTC-07:00
Powered by phpBB® Forum Software © phpBB Limited